Search found 604 matches
- Fri May 02, 2014 11:28 pm
- Forum: Technical Discussion
- Topic: Getting rid of a channel - Vibroverb
- Replies: 10
- Views: 1473
Re: Getting rid of a channel - Vibroverb
I want to do the opposite (removing the trem circuit instead of the reverb) because I never use it but I'm not sure how to terminate it..
- Thu May 01, 2014 6:59 pm
- Forum: Garage Talk
- Topic: Diabetes has struck.
- Replies: 69
- Views: 7921
Re: Diabetes has struck.
I was getting close to being type II a few years ago and after much research on my part I cut out HFCS (high fructose corn syrup) from EVERYTHING I eat or drink. That was hard, it's in most of the processed food and almost all soft drinks except diet drinks. But I did it and dropped my triglycerides...
- Thu May 01, 2014 3:42 am
- Forum: Technical Discussion
- Topic: Steel chassis - aluminum plugs??
- Replies: 9
- Views: 1384
Re: Steel chassis - aluminum plugs??
Combining different metals is always risky but if you put your ground wires to the steel chassis you should be ok. I have an amp that I did the same thing with and haven't had any issues.
- Thu May 01, 2014 3:30 am
- Forum: Technical Discussion
- Topic: 200Watt AB763
- Replies: 20
- Views: 1960
Re: 200Watt AB763
Set him (or her) up with a Crown PA amp and a pair of EAW stacks if they want to be that loud.
- Thu Apr 24, 2014 1:54 pm
- Forum: Technical Discussion
- Topic: Help locating a cap can: 1" diameter 100uF/250V....
- Replies: 12
- Views: 1421
Re: Help locating a cap can: 1" diameter 100uF/250V....
I've been getting posting errors too, don't re-post when you get that, just go back to the page you were reading and reload it. Your new post will be there.
- Wed Apr 23, 2014 4:54 pm
- Forum: Technical Discussion
- Topic: Ultimate Hammond Conversions thread
- Replies: 165
- Views: 204217
Re: Ultimate Hammond Conversions thread
Check the speaker ID sites and compare your codes there, mine came with a Jensen Alnico 35/40w 12".M Fowler wrote:Yes the organ speakers are good for guitar most often they are CTS speakers.
- Wed Apr 23, 2014 4:51 pm
- Forum: Technical Discussion
- Topic: Ultimate Hammond Conversions thread
- Replies: 165
- Views: 204217
Re: Ultimate Hammond Conversions thread
Funny but so far through this build, I kept telling myself it isn't worth the extra hassle of salvage/rebuild....then I end up picking this up for the cost of gas... I just picked up an M100 like that a couple of weeks ago. Eleven tubes on the amp... when I get my current project done I'm going to ...
- Tue Apr 22, 2014 2:33 pm
- Forum: Technical Discussion
- Topic: What do you guys think about this?
- Replies: 20
- Views: 2159
- Tue Apr 22, 2014 1:30 pm
- Forum: Technical Discussion
- Topic: What do you guys think about this?
- Replies: 20
- Views: 2159
Re: What do you guys think about this?
dupe post
- Tue Apr 22, 2014 1:30 pm
- Forum: Technical Discussion
- Topic: What do you guys think about this?
- Replies: 20
- Views: 2159
Re: What do you guys think about this?
When you say 22uf "bypass" cap on each tube, what are you referring to? I don't recall seeing caps on any power tubes in the amps I've worked on.
- Tue Apr 22, 2014 3:29 am
- Forum: Technical Discussion
- Topic: What do you guys think about this?
- Replies: 20
- Views: 2159
Re: What do you guys think about this?
This is what I came up with for the layout. Obviously the remainder of the pots aren't listed, this is just the board & components.
- Mon Apr 21, 2014 3:28 pm
- Forum: Technical Discussion
- Topic: What do you guys think about this?
- Replies: 20
- Views: 2159
Re: What do you guys think about this?
I'm not necessarily looking for a Vox tone, just something that speaks out with some attitude without being brash. I used that portion of a Vox schematic (minus two power tubes) because it was the quickest EL84 amp to find at the time. I'm also very open to other '84 power amp designs if you guys do...
- Mon Apr 21, 2014 3:22 am
- Forum: Technical Discussion
- Topic: What do you guys think about this?
- Replies: 20
- Views: 2159
Re: What do you guys think about this?
I figured the AT would drive the EL84s more than the AX but that's opposite of what it would actually do since the AX has more gain, right?
And by the 47/51K are you talking about changing the 100K resistors on the PI plates?
And by the 47/51K are you talking about changing the 100K resistors on the PI plates?
LOL! That made me laugh!hair in the PI (nooo pun intended!)
- Mon Apr 21, 2014 1:42 am
- Forum: Technical Discussion
- Topic: What do you guys think about this?
- Replies: 20
- Views: 2159
Re: What do you guys think about this?
This is exactly why I love this forum. Thanks guys, I will get started on it with the changes and see what happens.
- Sun Apr 20, 2014 11:11 pm
- Forum: Technical Discussion
- Topic: What do you guys think about this?
- Replies: 20
- Views: 2159
What do you guys think about this?
I want to build a low-wattage amp that has a chimey (Fender-style) preamp but will break up smoothly for a nice blues tone for small venues. EL84s seem like a good fit so if you don't mind I'd like some critique of this design. It's a take-off on a Vox power amp with a Fender pre-amp. It's going in ...