The Amp Garage

I bought this on the madbean forums. It's one of Brian's personal builds. Great for doing standard amp type reverb or slightly weirder stuff as it has some delay features too as it's a PT2399 + a Belton Brick. Has relay switching/bypass. I like it but don't really need it. $65 PPG or Venmo shipped i...

Same issue that happened here awhile back. Some browsers allow you to accept the dead certificate and visit anyway.

That is really cool, I'd never heard of it. I am definitely gonna have to play around with this.

Why not just use the turrets as a supports to wrap component leads around and solder the leads together? I know it's not ideal.

Aion electronics makes a PCB that is the entire preamp section of the lab series guitar amps w/ compressor. They have a pretty good amount information in the PDF on their site. https://aionfx.com/project/l5-preamp/ Not the lab series but here's info on Pearce Amps. Dan carried alot of what he learne...

I say go for it! but I am just up in Asheville, NC if you want someone else to do it or need help. I'm gonna be out of town the next two weeks but will be around after that. I'm somewhat familiar with those amps as I was working on a PCB for the preamp section of the Pearce G1 awhile ago but lost st...

Where in the SE exactly are you?

JJ has a pretty large cost advantage (definitely labor, most likely equipment, and I'd bet environmental as well) over anyone doing tube manufacturing here in the states. I'm sure for WE it comes down to what they want to be doing as a "brand". Do they wanna make low volume high end audio equipment ...

Yeah, it's a little tricky but honestly the learning curve isn't any worse than any other PCB software around. I use DxDesigner at work and either KiCad or my pre-autodesk Eagle license I have for home. my only advice would be plan for your libraries, it's the most annoying part. If you check out th...

Might be worth asking Peavey? They used to be pretty good with tech support on old products.

I would check out the diystomp or madbean forums to get an answer on that.

If it's rare why not just use it with a looper pedal and not mod it at all? Those are less than $50 new or you could build your own with 4x jacks and a DPDT switch.

Following up on what RG said. Big companies that have entire compliance departments tend to pay for all the testing they can across the board just to cover themselves. Smaller places may role the dice or not even understand. It may not be an issue until or unless you're caught for violating the rule...

Nice! hopefully that solves it!

Have you emailed Kustom? That amp is recent enough It might be worth a shot. Also, take some pictures of the PCB and wiring. We can probably collectively figure out what's going on. Channel switching usually isn't too mind blowing when it's done on the cheap.

It's also worth noting the original caps used were probably spec'd at something like -20%/+50% at very best so you can factor that into picking your new caps.