The Amp Garage

Funkalicousgroove wrote:
I plan to begin the auction on Monday at 8 AM,

Denver time?

Did you make the cabinet? Is there some kind of formula or plan for determining the exact dimensions of the oval port on the back?

Runaway J wrote: Had my place just in front of the stage in a very small (jazz)club.

"Very small" is right. It looks like you could reach over and tug on his pants leg to request a song.

Thanks for the tutorial.

Are the orange, red, and blue parts of the shielded cables all heatshrink?

I've just noticed that in my D'Lite, I somehow ended up with an RN65 C for the 121K resistor on V2 (the other three plate resistors are RN65D's). When you look up the RN65C on Mouser's site, it's described as a 1/4 watt resistor. This data sheet http://www.vishay.com/docs/31027/cmfmil.pdf , at p. 3 ...

I used a Weber W022723 ("Power Transformer for Tremolux, Vibrolux, Vibrolux Reverb") ($50) and a Heyboer HY404248 ("Multitap output transformer for general purpose use. 4K Primary, 2-4-8 secondary") ($48), both ordered from Weber. Both fit the Brownnote chassis perfectly.

Save target as . . . in Internet Explorer

Save link as . . . in Firefox

Mr. Fuchs: please read my PM. Thank you.

Normster -

Line 34 of the D'Lite BOM shows 2 1.5K resistors. Are these actually used? If so, where?

Ditto the 4.7K on line 39. (Is it an alternate to the 6.2K for the presence?)

never mind . . . .

I'm building a D'Lite (layout: http://bad-domain/DumbleLite/D-Lite%20Layout%20with%20Relays.jpg ; schematic: http://brownnote.net/forum/viewtopic.php?t=274 ), but using a 4K OT with 2-4-8 ohm taps instead of the standard 8K with 4-8-16. I have a few questions about the presence control. The layout i...

I see that a certain "funkaliciousgro***" submitted an offer . . .

Beerman - there is a link to the AO-44 schematic in the first post in this thread on the Hoffman forum:

http://www.el34world.com/Forum/yabb2/np ... 1189469245

(See the fourth and fifth pages of the .pdf file)

Regarding the Prosonic OT: Angela's website has the following description For repairs or build an ass kicking 50W combo (or head) with a pair of 6L6s. Upright end bell construction. Standard push-pull primary with three wires; red center tap, brown and blue plate leads. Somewhat unusual (for a Fende...