The Amp Garage

OK.

I have a hard time understanding what normally open/closed means....

Tommy

What kind of diodes do you guys use for rectification in the power supply?

Tommy

I think I might go for that. I've seen the schematics for how to wire this...but I'm still not sure about it.. The coil gets 6.3V (or whatever voltage it needs) to open/close the relay, I get that. Does the relay open/close when the foot switch connects the coil to ground, or lifts if from ground? T...

Is there a schematic for the post OD tone stack/equalizer that some use in their amps?

Tommy

Thanks!

What if fwb by the way?

Tommy

Ok.. nice. Is placing the reverb circuit with the dumbleator a better way of doing it than the normal placement, or is it just to make it convenient with the two circuits in the same chassis? I have a schematic I made (with some assistance) that has a built in dumbleator between the preamp/OD and po...

I can't decide on what kind of switching to use. some say that relays can make popping sounds, especially if there is a spring reverb in the circuit. Some say that optocouplers is the way to go, and others say analog switches should be used. To me, relays sounds like the easiest way.. Weber even sel...

I see that the bottom part is the reverb circuit.. But what is the upper part? Is it the dumleator, or is the whole thing for the reverb?

I wondered since there is an input, then a send and return, and then an output, in addition the the reverb part..

Tommy