Structo wrote:
Something I thought of because somebody here did it, was to just slide in the chassis on rails, then the back cover of the head holds it in.
Wow! And that's even thinking INSIDE the box!
I'm thinking a bit of strategic padding under what the chasssis slides in on might also help isolate from vibration for aiding control of microphonics.
I have used this style chassis before. I had Amplified Nation build me a cabinet that let me slide the chassis into the cabinet with no bolts and secure the chassis front and back by the opening frame in front and secured in the back by the rear cabinet cover.
It was locked in good and tight and the customer has never had a problem with this method. Here is a picture in its Buckskin suede cabinet.
You do not have the required permissions to view the files attached to this post.
Structo wrote:
Something I thought of because somebody here did it, was to just slide in the chassis on rails, then the back cover of the head holds it in.
I did this originally. Worked great until the amp went over on it's face one night during load out, and the chassis busted right out through the front of the cab.
Wound up putting screws through the sides after that.
...and stopped putting the amp on the dolly.
<i> "I've suffered for my music. Now it's your turn."</i>
groovtubin wrote:A friend got one, and it doesn`t have any mounting points, would someone kindly point me to the thread that addresses that issue? Thanks!
groovtubin wrote:A friend got one, and it doesn`t have any mounting points, would someone kindly point me to the thread that addresses that issue? Thanks!
Does anyone have a part number for those threaded inserts? I need some for a project. I tried searching but couldn't find the countless threads I have seen them in
amplifiednation wrote:Does anyone have a part number for those threaded inserts? I need some for a project. I tried searching but couldn't find the countless threads I have seen them in
amplifiednation wrote:Does anyone have a part number for those threaded inserts? I need some for a project. I tried searching but couldn't find the countless threads I have seen them in
OK, I am ready to order these, of course I have to get 50 of them! Haha...not expensive though.
Would you recommend the weld nut with tab base and center pilot, then drill small holes to chassis mount it...or is the weld nut with tab base, center pilot, and 'projections' the same thing with the holes already drilled? Is that what the 'projections' are?
amplifiednation wrote:Does anyone have a part number for those threaded inserts? I need some for a project. I tried searching but couldn't find the countless threads I have seen them in
OK, I am ready to order these, of course I have to get 50 of them! Haha...not expensive though.
Would you recommend the weld nut with tab base and center pilot, then drill small holes to chassis mount it...or is the weld nut with tab base, center pilot, and 'projections' the same thing with the holes already drilled? Is that what the 'projections' are?