The major change in the circuit I propose in the files section is, as I say there, moving the cap to ground from one of the treble switch's position contacts to its center pole. That is what brings the treble response into line.
Bombacaototal wrote: ↑Tue Apr 25, 2017 8:38 pm
In my opinion there are other mistakes on the filters
I think before them it should be like the attached
If I did this with the SSS002, do you think I should place the 0.003 cap back to where it is on the Japanese schematic? I currently have it as per the May Contain Errors schematic.
Bombacaototal wrote: ↑Tue Apr 25, 2017 8:38 pm
In my opinion there are other mistakes on the filters
I think before them it should be like the attached
If I did this with the SSS002, do you think I should place the 0.003 cap back to where it is on the Japanese schematic? I currently have it as per the May Contain Errors schematic.
I would do it like attached. Let me know how it works out for you
You do not have the required permissions to view the files attached to this post.
Bombacaototal wrote: ↑Tue Apr 25, 2017 8:38 pm
In my opinion there are other mistakes on the filters
I think before them it should be like the attached
If I did this with the SSS002, do you think I should place the 0.003 cap back to where it is on the Japanese schematic? I currently have it as per the May Contain Errors schematic.
I would do it like attached. Let me know how it works out for you
No matter what I do, once I move the 3nF cap to switch position 7 to ground and take if off the common cap point, the non bypass positions are harsh as h#ll. With the .01 separated there is a marginal change in tone but not much difference.