anyone tried Cold clipping third stage (in a Dumble)?
I was wandering for results
Sofar I have a Ripper (third and fourth stage like a jcm800) which sound good but not THAT GOOD
so i was wandering how to get a nice OD out of those two stage (without using the dumble OD way)
anyone tried Cold clipping third stage (in a Dumble)?
Moderators: pompeiisneaks, Colossal
anyone tried Cold clipping third stage (in a Dumble)?
Soy de Chile y tu?
- boldaslove6789
- Posts: 957
- Joined: Mon Aug 31, 2009 5:52 pm
- Location: Near Dallas, TX
Re: anyone tried Cold clipping third stage (in a Dumble)?
The ripper topology is a really hard circuit to make sound great yet like other known ODS topologies as this circuit hasnt really been divulged in detail yet. I think there is more going on than what's known.
Imo, I think you'd be better off cascading 1 clean preamp (skyline or classic derived) into 2 disimilar OD circuits into each other or one or the other.
Henry at Redplate does this in the Magic dust duo. With the ability to run both HRM and non-HRM OD circuits seperately, or run them in series. But with a tweed fender single tone control Clean Preamp. Pretty cool sounding and very versatile and Musical.
Imo, I think you'd be better off cascading 1 clean preamp (skyline or classic derived) into 2 disimilar OD circuits into each other or one or the other.
Henry at Redplate does this in the Magic dust duo. With the ability to run both HRM and non-HRM OD circuits seperately, or run them in series. But with a tweed fender single tone control Clean Preamp. Pretty cool sounding and very versatile and Musical.
Greg D.C.
Can you dig it?
(NEW VIDS here!!) http://www.youtube.com/user/GDClarkProject
http://quinnamp.com/ http://www.prairiewoodguitars.com/
http://www.funkymunkpedals.com/
Can you dig it?
(NEW VIDS here!!) http://www.youtube.com/user/GDClarkProject
http://quinnamp.com/ http://www.prairiewoodguitars.com/
http://www.funkymunkpedals.com/