want 2 Rok JM signature tone board layout

[M Fowler]

Looking for layout for the 2 Rok JM signature tone board.

Mark

[M Fowler]

Okay I will use this board for my drill pattern.

[AtomCap]

very average looking build quality....
raises brow..

[M Fowler]

That was a clone someone built of the Two Rock.

[Structo]

Looks a little cramped.

Hard to fit resistors with eyelets that close.

I would use a standard Dumble layout for that.

[hitchcaster]

That was a clone someone built of the Two Rock.

I don't think so... looks like a two rock to me... their caps.... polarity markings....

[talbany]

Anybody know what Carbon films those are?

Tony

[M Fowler]

I'm drawing up my own board since I need to know where all those board components go anyway I might as well do it my way. This 2 Rok has reverb loop. Five preamp tubes.

[ToneMerc]

Anybody know what Carbon films those are?

Tony

Tony I very briefly researched these awhile back, my best guess without having any in hand was Vishay Draloric LCA series, .6 watts

TM

[talbany]

Anybody know what Carbon films those are?

Tony

Tony I very briefly researched these awhile back, my best guess without having any in hand was Vishay Draloric LCA series, .6 watts

TM

Thanks Mike (aka Resistor Man)..Was thinking they have a Draloric look about them.. Any ideas as to where to get these..

Thanks!!

T

[ToneMerc]

Anybody know what Carbon films those are?

Tony

Tony I very briefly researched these awhile back, my best guess without having any in hand was Vishay Draloric LCA series, .6 watts

TM

Thanks Mike (aka Resistor Man)..Was thinking they have a Draloric look about them.. Any ideas as to where to get these..

Thanks!!

If I had to guess again, bet they are close to the Q-lines (Draloric) HAD used.

Tony in the past I have ordered non-stock small special orders from Allied Electronics , but I don't think they do that anymore. My choice if I really wanted to chase these would to contact Farnell to see if they would do a small quanity special order. I would not even consider Mouser, I bet a min order would be 500 or 1000 of each value.

I bet TR gets them directly from the manufacturer.

TM

[Aaron]

This might help your quest

http://ampgarage.com/forum/viewtopic.php?t=18824

Aaron

EDIT:- revised schem posted on page 3

[Structo]

I don't understand that layout at all.
Why would you cram all the components into a 1/3 of the board when there is plenty of room to spread things out?

Is there any sonic advantage to the crammage?

[M Fowler]

Is there any sonic advantage to the crammage?

Oh, yes, it eliminates cross talk being so nice and close together, living in harmony.

Mark

[dreric]

I don't understand that layout at all.
Why would you cram all the components into a 1/3 of the board when there is plenty of room to spread things out?

Is there any sonic advantage to the crammage?

Years ago I talked to Bill or the other TR guy whose name I forget. They had just released an amp called the Opal which, I was told, was kind of a point to point Dumble. Their idea was that lead / wire = noise and a longer response time. By having things with less lead/wire = less noise and faster response.

Personally, I find their amps funny looking and a bit sloppy for the money. That said, they sound pretty good, so what do I know?