Check this out......

[Smokebreak]

Redshark, thanks for the pics thusfar. Did you happen to get any of the rest of the pots?

[redshark]

Some pots.....

[redshark]

more pots.....

[splgeo]

very cool man

[butwhatif]

Did you possibly get an ohms measurement on the 100k trimmer, that is glued in place. ?

[redshark]

Yes, I did.....

91.4k

[butwhatif]

did you get a slider position measurement in that---referenced to ground? thanks,

[Smokebreak]

Yes, I did.....

91.4k

yowza!

[butwhatif]

wow was that thing cranked !

[Smokebreak]

That accounts for the dirt that amp has at low settings.

[redshark]

That accounts for the dirt that amp has at low settings.

Yes, it's a gainy amp. With this amp if you want Ford-Carlton tones you need to use the jazz switch.

[butwhatif]

Redshark, did you get values for the snubber caps?

[Charlie Wilson]

I am curious Redshark. How was the OD trimmer measured? Typically to measure the setting, the amp is on (not on standby) and in OD mode and it is measured from the wiper to ground. I only ask because if you measure across the timmer with the amp off, you get a slightly lower then marked value of the trimmer. Thanks again for the intel.
CW

[redshark]

Charlie, the amp was off when I took measure.
I will look for more pics of the amp.

Question....

Can I get a part number for the male plug to try to build a footswitch for the amp?

Thanks!!

[ToneMerc]

Charlie, the amp was off when I took measure.
I will look for more pics of the amp.

Question....

Can I get a part number for the male plug to try to build a footswitch for the amp?

Thanks!!

Thought I was going to be able to send you one for your kindness, I searched my parts bin and found the fem 4 pin XLR jack and the plug housing, but the not the 4 pin plug internals....sucks.

Mouser 502-A4M

TM