Dumble Clone Parts: Who's Selling?
Moderators: pompeiisneaks, Colossal
Dumble Clone Parts: Who's Selling?
Sorry for my ignorance but can anyone direct me to who if anyone is selling parts for Dumble clones, Dumble-Lite, etc?
Re: Dumble Clone Parts: Who's Selling?
There's not a single source. Chassis and cabinets available from http://amplifiednation.com, transformers from classictone.net or tubesandmore.com, small parts from tubesandmore.com, etc etc.
Something specific you're asking about?
Something specific you're asking about?
I build and repair tube amps. http://amps.monkeymatic.com
Re: Dumble Clone Parts: Who's Selling?
If your going to be using relays in that Dumble Lite I would order PT from Heyboer with voltage tap for the relays.
Re: Dumble Clone Parts: Who's Selling?
My PT has two 6.3VDC taps so I'll get my relay voltage from those and use 12V for the filaments too....
I'm looking for the relay boards without the relays
TT
I'm looking for the relay boards without the relays
TT
Re: Dumble Clone Parts: Who's Selling?
This is what I'm looking for.....
You do not have the required permissions to view the files attached to this post.
-
- Posts: 505
- Joined: Tue Jun 06, 2017 12:20 pm
- Location: Montreal, Canada
Re: Dumble Clone Parts: Who's Selling?
Same here, I am willing to buy relay boards like 6-10. I live in Canada.tictac wrote:This is what I'm looking for.....
Fred.
Fred.
- norburybrook
- Posts: 3290
- Joined: Mon Jan 06, 2014 12:47 am
- Location: London
- Contact:
Re: Dumble Clone Parts: Who's Selling?
you can make these. Just use 1/16 eyelets for the relay pins. Solder thin wire from the 1/16 eyelets to the 1/8 ones, the relays will still push in to solder in place.
The 1/16 eyelets don't need a staking tool just put them on something flat and tap them with a hammer, the rear will spread enough to hold in place, or perhaps I used a center punch. Whatever, they're easy to make if a little fiddly.
M
The 1/16 eyelets don't need a staking tool just put them on something flat and tap them with a hammer, the rear will spread enough to hold in place, or perhaps I used a center punch. Whatever, they're easy to make if a little fiddly.
M
Re: Dumble Clone Parts: Who's Selling?
https://www.ebay.com/
Here is where I get most of my NOS ODS obscure parts.Be patient and dig worldwide grasshopper!. My last ODS build took 6 months of searching
Tony
Here is where I get most of my NOS ODS obscure parts.Be patient and dig worldwide grasshopper!. My last ODS build took 6 months of searching
Tony
" The psychics on my bench is the same as Dumble'"