rutledj wrote:I'll go Non-hrm for now and try to figure out the switching later after I have something that works.
Schematic for your feedback
Moderators: pompeiisneaks, Colossal
Re: Schematic for your feedback
You'll need to completely revamp everything. Your entire OD section is now wrong, as well as no bright cap on clean master.....
Re: Schematic for your feedback
Presence is good now
Former owner of Music Mechanix
www.RedPlateAmps.com
www.RedPlateAmps.com
Re: Schematic for your feedback
Arrrgh!! Apparently there is a way for both of these to live together under one chassis (ala Glasswerks). I guess I need to get the Non-Hrm working then tweak from there.
Rut
Rut
Re: Schematic for your feedback
Added ckt around Master clean so when it is switched out it will work properly.
You do not have the required permissions to view the files attached to this post.
Re: Schematic for your feedback
That is only if you remove the clean master load if you are doing seperate masters and nonHRM/HRM with switch. My advice is to chose one circuit or the other. Try the HRM. You can always convert it to non.....
rutledj wrote:Added ckt around Master clean so when it is switched out it will work properly.