Hi,
Anybody take backside board pictures of they"re #124 builds?
Looking for jumper picks and under board wiring. Some of the board pictures are hard to see through, espeicially the "FET" board.
Thank you, Brian
Pictures of the backsides of the boards....
Moderators: pompeiisneaks, Colossal
-
- Posts: 1053
- Joined: Fri Apr 16, 2010 9:04 am
- Location: Santa Cruz, CA
1 others liked this
Re: Pictures of the backsides of the boards....
You can get a good idea from these layouts. Reverse engineer and apply to whatever layout you are using . https://ampgarage.com/forum/viewtopic.p ... t=Bias+fet
Charlie
Re: Pictures of the backsides of the boards....
Thank you, Those are the ones I'm using. The fet board is hard to trace, top left by the pot...
Brian
Brian
You do not have the required permissions to view the files attached to this post.
- martin manning
- Posts: 13207
- Joined: Sun Jul 06, 2008 12:43 am
- Location: 39°06' N 84°30' W
1 others liked this
Re: Pictures of the backsides of the boards....
All three eyelets at the top left on the FET board are ground, all tied together. The output eyelet only goes to the middle of the pot, the wiper.
Re: Pictures of the backsides of the boards....
so, top three from left to right go to ground, output goes to center post of the pot and 47u cap goes to lower pot?
Just trying to not go poof.......
Brian
Just trying to not go poof.......
Brian
- martin manning
- Posts: 13207
- Joined: Sun Jul 06, 2008 12:43 am
- Location: 39°06' N 84°30' W
Re: Pictures of the backsides of the boards....
Correct. 4.7uF though.
Re: Pictures of the backsides of the boards....
Yup, 4.7
Thanks all, Brian
Thanks all, Brian