Hi
I noticed an inconsistance in the layout and the schematic
maybe this has already been discussed but I couldn't find the answer
on the 100uf cap on the FET board the layout shows it being 25V
and the schematic shows it at 50v this is the cap adjacent to
the 8.2k resistor does it matter if I use 25v vs 50v?
#124 question
Moderators: pompeiisneaks, Colossal
- martin manning
- Posts: 13163
- Joined: Sun Jul 06, 2008 12:43 am
- Location: 39°06' N 84°30' W
Re: #124 question
I'd make it 50V. The working voltage is 20 or so, but with tubes out it could exceed 25V.