![Smile :)](./images/smilies/icon_smile.gif)
Search found 33 matches
- Mon Jan 19, 2009 3:32 am
- Forum: Dumble Discussion
- Topic: Weird behavior when measuring OD entrance trimmer.
- Replies: 15
- Views: 1433
Re: Weird behavior when measuring OD entrance trimmer.
As I said, mine does do that same thing Tonegeek's does. That said, I do measure mine with the power off. ![Smile :)](./images/smilies/icon_smile.gif)
![Smile :)](./images/smilies/icon_smile.gif)
- Mon Jan 19, 2009 3:27 am
- Forum: Dumble Discussion
- Topic: Built-in D'lator: To shield or not to shield
- Replies: 5
- Views: 712
Re: Built-in D'lator: To shield or not to shield
Ah... Lights are on low, but they are working now...heisthl wrote: The PI rejects hum, your OD is geting 44uf and your CL is getting 66uf, are the lights turning on yet?
![Wink ;)](./images/smilies/icon_wink.gif)
Thanks..
- Mon Jan 19, 2009 12:32 am
- Forum: Dumble Discussion
- Topic: Built-in D'lator: To shield or not to shield
- Replies: 5
- Views: 712
Re: Built-in D'lator: To shield or not to shield
Some seem to think that part of the mojo is the capacitance of the shielded wire rolling off a bit of high end. Some of the stage photos I've seen show guitar cords (not patch cables, 15'-20' of guitar cord) connecting the amp to the D'lator. You'd be hard pressed to put that much cable into your a...
- Sat Jan 17, 2009 10:40 pm
- Forum: Dumble Discussion
- Topic: Built-in D'lator: To shield or not to shield
- Replies: 5
- Views: 712
Built-in D'lator: To shield or not to shield
I just installed an built-in D'lator in my 2x6L6 test build. The layout file 97_ODS_HRM_loop.jpg was helpful. I think that might have been Normster's layout. I ended up just using one Resistor and Cap to make an extra node for the d'lator power. I know there are some that say you need as much as 4 e...
- Fri Jan 16, 2009 11:31 am
- Forum: Dumble Discussion
- Topic: New D'lite 44 build pic's
- Replies: 67
- Views: 6399
Re: New D'lite 44 build pic's
Interesting.. I might try that. Where do you end up grounding the shielding? Near the tube?heisthl wrote:My run there is usually about 4" but it makes an audible difference in taming any harshness.
- Fri Jan 16, 2009 11:14 am
- Forum: Dumble Discussion
- Topic: Weird behavior when measuring OD entrance trimmer.
- Replies: 15
- Views: 1433
Re: Weird behavior when measuring OD entrance trimmer.
You would think measuring the resistance of the OD trimmer would be the same whether amp is off or not but in this case: Resistance of OD entrance trimmer from wiper to ground with amp off = 13.7k same measurement with amp on but on standby = 8.1k same measurement with amp on, standby off = 13.7k I...
- Fri Jan 16, 2009 11:03 am
- Forum: Dumble Discussion
- Topic: Low pf shielded cable
- Replies: 54
- Views: 6862
Re: Low pf shielded cable
Some of the older amps -- the holy grail ones to some -- with the Radio Shack shielded wire probably have in excess of 100pF per foot... add it all up, and it begins to make an audible difference. I am using bunch of shielded wire removed from a set of old organs. I just tested it. Comes in at 90+ ...
- Fri Jan 16, 2009 10:22 am
- Forum: Dumble Discussion
- Topic: Which preamp tubes do you use in your ODS?
- Replies: 50
- Views: 7465
Re: Which preamp tubes do you use in your ODS?
Currently:
Preamp: EH - 12AX7
OD-Section: GT-12AX7M
built-in Dumbleator: EH - 12AX7
PI: EH - 12AX7
Preamp: EH - 12AX7
OD-Section: GT-12AX7M
built-in Dumbleator: EH - 12AX7
PI: EH - 12AX7
- Mon Jan 05, 2009 10:43 pm
- Forum: Dumble Discussion
- Topic: Getting that Dumble or D Clone Tone?
- Replies: 61
- Views: 7303
Re: Getting that Dumble or D Clone Tone?
It will be interesting to see what you think.Structo wrote:I ordered a EVM 12L Classic from AMS.
Should get it later this week.
- Mon Jan 05, 2009 10:41 pm
- Forum: Dumble Discussion
- Topic: D'lite 6L6 build: Bright!
- Replies: 45
- Views: 6253
Re: D'lite 6L6 build: Bright!
But I couldn't get rid of the harshness, no matter, where the OD trim pot was set to. The Ceriatone OT seems to be better suited for British Style sounds than for dumble-ish IMO, so I've installed a fix treble bleed after the resistor after OD2's plate with a .001 Silver Mica and a 390K to ground, ...
- Mon Jan 05, 2009 7:12 pm
- Forum: Dumble Discussion
- Topic: D'lite 6L6 build: Bright!
- Replies: 45
- Views: 6253
Re: D'lite 6L6 build: Bright!
I have now installed an treble bleed with 500K pot. And it seems to be working nicely. I have it set somewhere around 100K. The snubbers are currently 250p. This amp is starting to come into shape. Anyhow, I want to thank everyone for their help so far. ![Smile :)](./images/smilies/icon_smile.gif)
![Smile :)](./images/smilies/icon_smile.gif)
- Mon Jan 05, 2009 12:25 pm
- Forum: Dumble Discussion
- Topic: Getting that Dumble or D Clone Tone?
- Replies: 61
- Views: 7303
Re: Getting that Dumble or D Clone Tone?
Thanks for the info. It's helpful.
Sorry for the double post.
- Mon Jan 05, 2009 12:33 am
- Forum: Dumble Discussion
- Topic: Getting that Dumble or D Clone Tone?
- Replies: 61
- Views: 7303
Re: Getting that Dumble or D Clone Tone?
I've built a few of these and they're consistently great sounding amps. Very smooth and forgiving OD. Check out Mitch Farber playing on at the NY Amp Show: http://www.youtube.com/watch?v=DBaeF61HYcI&feature=related (Chuck's playing a bluesmaster) Wow, I like that bluesmaster clip. which schematic i...
- Mon Jan 05, 2009 12:32 am
- Forum: Dumble Discussion
- Topic: Getting that Dumble or D Clone Tone?
- Replies: 61
- Views: 7303
Re: Getting that Dumble or D Clone Tone?
I've built a few of these and they're consistently great sounding amps. Very smooth and forgiving OD. Check out Mitch Farber playing on at the NY Amp Show: http://www.youtube.com/watch?v=DBaeF61HYcI&feature=related (Chuck's playing a bluesmaster) Wow, I like that bluesmaster clip. which schematic i...
- Sun Jan 04, 2009 8:53 am
- Forum: Dumble Discussion
- Topic: D'lite 6L6 build: Bright!
- Replies: 45
- Views: 6253
Re: D'lite 6L6 build: Bright!
Isn't the red, white and blues designed after either an JBL or EV?Structo wrote:I've heard a few guys like the Eminence Red, White and Blues speakers in the D clones.