I would measure it myself but the amp is almost complete. My original intention was to get the standard wood faceplate, but now I want a custom metal plate.
I plan on using BNP Lasers and she needs me to send her a template. If someone has the measurements or a template they could post or pm to me I would greatly appreciate it. It's one of Allyn's chassis'.
Thanks!
Jeff
Anyone have an Express faceplate template?
Moderators: pompeiisneaks, Colossal
- martin manning
- Posts: 13549
- Joined: Sun Jul 06, 2008 12:43 am
- Location: 39°06' N 84°30' W
Re: Anyone have an Express faceplate template?
Measure it yourself. That is the only way to get an exact fit. If Allyn has the hole pattern that will help, but I would still verify the length, distance from the end to the input jack, and the centerline height off the lower edge at both ends.
Re: Anyone have an Express faceplate template?
http://ampgarage.com/forum/files/Trainw ... _panel.jpg
http://ampgarage.com/forum/files/headcab.pdf
Myself, I would cut the faceplate 1/8" bigger, and trim it to fit after the cabinet is built.
John
http://ampgarage.com/forum/files/headcab.pdf
Myself, I would cut the faceplate 1/8" bigger, and trim it to fit after the cabinet is built.
John
Re: Anyone have an Express faceplate template?
These are to scale.
Have Fun,
Bob
Have Fun,
Bob
You do not have the required permissions to view the files attached to this post.
Why Aye Man
Re: Anyone have an Express faceplate template?
Thanks Bob! Andthanks again for the cabinet builder recommendation.