Hiwatt Chassis...

[cbass]

Finally got to put a little solder down.... Got my 220uf 385v F&T cap cans in the mail today (hard to source this side of the pond) but was able to find them at c3amps after searching forever and am still looking for the 32+16 dual section can ( again hard to source this side of the pond) it's looking like Europe for that... after that, I will have all the goods to complete the amp.... the weather is getting crappy and winter my favorite time to build...

http://www.shop.hi-tone-amps.com/ARS-16 ... 32-ARS.htm

Won't these work? Or are you holding out for F&T.

Thanks!!

It says their hitone caps are made by f&t it looks like everything on thier site is backordered

[lord preset]

http://www.shop.hi-tone-amps.com/ARS-16 ... 32-ARS.htm

Won't these work? Or are you holding out for F&T.

Thanks!!

It says their hitone caps are made by f&t it looks like everything on thier site is backordered

Oh. Bummer - I didn't notice that. Never mind.

[playonit]

I ordered the cap... it didn't say Back ordered when I placed the order.. I may have got the last one.. ordered that and the heat shield.. got the order confirm today.. fingers crossed..

[playonit]

Did up the heater wiring... Wish I could do a cleaner job but I guess that will come in time and more builds. Also wired in the OT...

[beasleybodyshop]

Play, what are the dimensions of your hiwatt chassis?

[playonit]

Dimensions are 19" x 9.375 x 2.750

I got my chassis from Allynmey here on the TAG... he still might have a couple left... well worth it over the aggravation of punching your own...


More dimensions herehttp://hiwatt.org/DIY/HWchassisTop.jpg