Bludotone EL34 HRM

[ayan]

amazing worksmanship, epoxy under everything so it won't move... incredible

It's not epoxy, it's silicone rubber, like Dumble uses in his amps:

http://ampgarage.com/forum/viewtopic.ph ... p&start=45

Cheers,

Gil

[Mark]

Thanks for the reply on the caps. We don't see NTE or CDE caps in Australia.

http://direct-components.com/osc/index.php?cPath=22_39

[Stratoblaster]

Thanks for the reply on the caps. We don't see NTE or CDE caps in Australia.

http://direct-components.com/osc/index.php?cPath=22_39

Mark,
Ive purchased any Mouser product from these guys here in Australia
http://www.x-on.com.au/
They use same part numbers as well, must be agents.
Cheers

[Mark]

Thanks for that Stratoblaster, Mouser's postage starts at $40,I have to buy a lot of component to even consider that.

[Tonegeek]

Amp and playing sound great. Brandon's successful use of the polyester caps gives me the courage to try the same. Maybe he will chime in and give his opinion on the tonal difference between the Xicon MPP, the Nichicon Polyester and the Orange PS caps.

[Ang3lus]

does he use them in all of his amps ?

[gmule12]

is the PI have 220k and 91k resistor or that 120k and 91k and on the top 2x 100K on the other side ?

[gmule12]

And one more. After looking closely at picture l see that on V2, where all schematic's show 68k resistor on the picture looks like 6.8k blue, grey and red, not orange. It's clear colour red. Any one can confirm that.?

[erwin_ve]

Pi is 110k.
The v2 grid is 68k.
Colours are always a bit tricky on monitors.