Check this out......
Moderators: pompeiisneaks, Colossal
-
- Posts: 1391
- Joined: Tue Dec 18, 2012 5:53 pm
- Location: Texas
Re: Check this out......
Redshark, thanks for the pics thusfar. Did you happen to get any of the rest of the pots?
Re: Check this out......
Some pots.....
You do not have the required permissions to view the files attached to this post.
Re: Check this out......
more pots.....
You do not have the required permissions to view the files attached to this post.
Re: Check this out......
Did you possibly get an ohms measurement on the 100k trimmer, that is glued in place. ?
Re: Check this out......
Yes, I did.....
91.4k
91.4k
Re: Check this out......
did you get a slider position measurement in that---referenced to ground? thanks,
-
- Posts: 1391
- Joined: Tue Dec 18, 2012 5:53 pm
- Location: Texas
Re: Check this out......
yowza!redshark wrote:Yes, I did.....
91.4k
Re: Check this out......
wow was that thing cranked !
-
- Posts: 1391
- Joined: Tue Dec 18, 2012 5:53 pm
- Location: Texas
Re: Check this out......
That accounts for the dirt that amp has at low settings.
Re: Check this out......
Yes, it's a gainy amp. With this amp if you want Ford-Carlton tones you need to use the jazz switch.Smokebreak wrote:That accounts for the dirt that amp has at low settings.
Re: Check this out......
Redshark, did you get values for the snubber caps?
-
- Posts: 1123
- Joined: Thu Jan 23, 2014 7:32 pm
- Location: Laguna Niguel, California
Re: Check this out......
I am curious Redshark. How was the OD trimmer measured? Typically to measure the setting, the amp is on (not on standby) and in OD mode and it is measured from the wiper to ground. I only ask because if you measure across the timmer with the amp off, you get a slightly lower then marked value of the trimmer. Thanks again for the intel.
CW
CW
Re: Check this out......
Charlie, the amp was off when I took measure.
I will look for more pics of the amp.
Question....
Can I get a part number for the male plug to try to build a footswitch for the amp?
Thanks!!
I will look for more pics of the amp.
Question....
Can I get a part number for the male plug to try to build a footswitch for the amp?
Thanks!!
Re: Check this out......
Thought I was going to be able to send you one for your kindness, I searched my parts bin and found the fem 4 pin XLR jack and the plug housing, but the not the 4 pin plug internals....sucks.redshark wrote:Charlie, the amp was off when I took measure.
I will look for more pics of the amp.
Question....
Can I get a part number for the male plug to try to build a footswitch for the amp?
Thanks!!
Mouser 502-A4M
TM