OK tube amp building lunatic friends, I need help. Mojotone has an order policy for chassis' and I cannot use them for prototyping(25 minimum order)
I need a metal worker, or metal fabricator to help me get new amplifier chassis' built for my company, I work off of CAD software for cut holes and dimensions, BUT I can't work in 3D yet. I use Cruzey for my square chassis, but he can't to the fender style to his liking.
The chassis I need is a basic princeton fender reverb chassis dimensions and bends. BUT I have different front and rear panel cut outs for the new circuit.
thanks in advance for any help from the lords of tube-ery!!!
Chassis building/fabrication place/company........
Moderators: pompeiisneaks, Colossal
- Curranproducer
- Posts: 285
- Joined: Sun Oct 16, 2011 4:58 pm
- Location: Akron, Ohio
Chassis building/fabrication place/company........
Curran
Owner of Custom Audio Mutation Recording Studio, Guitar/Amp/Pedal Repair, and Mod center in Akron Ohio
Devout Distortion Worshipper and fan of warm hugs
234-788-6141
Owner of Custom Audio Mutation Recording Studio, Guitar/Amp/Pedal Repair, and Mod center in Akron Ohio
Devout Distortion Worshipper and fan of warm hugs
234-788-6141
Re: Chassis building/fabrication place/company........
Have you tried reaching out to any local small fab shops? Akron must have at least one smaller shop with a laser cutter and those bends aren't too bad.
https://tfrelectronics.com/
https://oshpark.com/profiles/TFRelectronics
https://oshpark.com/profiles/TFRelectronics