Reverb Driver Voltage Supply
Moderators: pompeiisneaks, Colossal
-
- Posts: 1675
- Joined: Thu Oct 06, 2016 5:53 am
Reverb Driver Voltage Supply
I am wondering which of the 2 options (circled in red under the attached) would be best to add a voltage dropping resistor to the Reverb Driver
1) The one on the left, just next to the Screen Grid supply seems to be the approach Two Rock took on the Matt Schofield amp (although I cannot confirm 100%). Although I would assume an extra 20uF would be needed for this
2) The one on the right between the mixer and PI supply is the one Two Rock used on the John Mayer amp (which I can confirm)
My circuit is most similar to the Schofield (Fender blackface).
Blurry gut shot of Schofield amp here http://ampgarage.com/forum/viewtopic.php?f=4&t=30074
Mayer's amp here: http://ampgarage.com/forum/viewtopic.php?f=4&t=29774
1) The one on the left, just next to the Screen Grid supply seems to be the approach Two Rock took on the Matt Schofield amp (although I cannot confirm 100%). Although I would assume an extra 20uF would be needed for this
2) The one on the right between the mixer and PI supply is the one Two Rock used on the John Mayer amp (which I can confirm)
My circuit is most similar to the Schofield (Fender blackface).
Blurry gut shot of Schofield amp here http://ampgarage.com/forum/viewtopic.php?f=4&t=30074
Mayer's amp here: http://ampgarage.com/forum/viewtopic.php?f=4&t=29774
You do not have the required permissions to view the files attached to this post.
Re: Reverb Driver Voltage Supply
What type of reverb driver tube/stage? (12AX7, 12AT7,12AU7, or some type of tetrode or pentode?)
He who dies with the most tubes... wins
-
- Posts: 1675
- Joined: Thu Oct 06, 2016 5:53 am
Re: Reverb Driver Voltage Supply
Then any supply around 400-440ish will be okay. So it'll be fine at the screen node - put the driver tube's circuit returns at the same filter cap ground.
He who dies with the most tubes... wins
-
- Posts: 1675
- Joined: Thu Oct 06, 2016 5:53 am
-
- Posts: 1675
- Joined: Thu Oct 06, 2016 5:53 am
Re: Reverb Driver Voltage Supply
As far as the blackface tremolo (roach) a 22k dropping resistor should be fine?
-
- Posts: 1675
- Joined: Thu Oct 06, 2016 5:53 am
Re: Reverb Driver Voltage Supply
a 12AX7 will draw ~2mA, so 22k x 2mA = 44V drop. That should tell you where you will land with the HT voltage for the oscillator. Any HT voltage between about 250 and 440 will be ample for getting the oscillator to work.
He who dies with the most tubes... wins
-
- Posts: 1675
- Joined: Thu Oct 06, 2016 5:53 am