Had to do the cap stack at "an angle"
![Shocked :shock:](./images/smilies/icon_eek.gif)
Otherwise the caps on top of each other, would have been higher than the base plate. Strange!!
Anyway, nearly there.
Couldn't use the earth buss attachments.(almost like a washer with a "leg"). Will post a pic. Firstly, they do not work with the PEC pots. The pots are thicker than average. Secondly, if I did use them, I would not have enough clearance on the pot thread for a wooden face plate. Hope this makes sense!
I will have to solder copper earth buss to the back of the pots. Not my best choice.
I would like to separate the power supply node earths.
1. Power tubes and PI (3 bottom caps) at one spot (near PS caps?)
2. Preamp B+3, 4 and 5 (top 3 caps) at one spot (where?). Maybe at input jack?
3. CT's and PT Earth at one spot (as per pic)
Any input welcome.