I had to do some upgrades on 3 of my amps so I had them all out of the cabs at the same time so I thought I would take a quick shot and share it..Sorry about the quality all I have is my phone
Left to right....Low plate classic/Low plate Skyliner Music Man/High plate Skyliner (separate bias pots)
Tony
20210220_173451.jpg
You do not have the required permissions to view the files attached to this post.
Last edited by talbany on Sat Feb 20, 2021 11:24 pm, edited 1 time in total.
" The psychics on my bench is the same as Dumble'"
ijedouglas wrote: ↑Sun Feb 21, 2021 12:49 am
Very nice! Are those 1 watt Q-Lines on the OD out?
Yes although I believe Draloric listed them as 0.7 Watts under the 0617 Type..I am not sure if Sprague listed them as 1 watt on the package? The 100k's are 5% Tolerance and both have the yellow band IMO same resistor.. W.German
Tony
Last edited by talbany on Sun Feb 21, 2021 1:28 am, edited 1 time in total.
" The psychics on my bench is the same as Dumble'"
ijedouglas wrote: ↑Sun Feb 21, 2021 12:49 am
Very nice! Are those 1 watt Q-Lines on the OD out?
Yes although I believe Draloric listed them as 0.7 Watts under the 0617 Type..I am not sure if Sprague listed them as 1 watt on the package? The 100k's are 5% Tolerance and both have the yellow band W.German
Tony
I have the same ones. Sprague listed them as 1 watt on the package. How do they sound compared to the 1/2 watt?
ijedouglas wrote: ↑Sun Feb 21, 2021 12:49 am
Very nice! Are those 1 watt Q-Lines on the OD out?
Yes although I believe Draloric listed them as 0.7 Watts under the 0617 Type..I am not sure if Sprague listed them as 1 watt on the package? The 100k's are 5% Tolerance and both have the yellow band W.German
Tony
I have the same ones. Sprague listed them as 1 watt on the package. How do they sound compared to the 1/2 watt?
Hard to say right now? being as I only have 1 half watt in the amp and it's in the PI and I literally just installed it today the jury is still out but so far it sounds like a Q-line (thumpy)
Thanks!
Tony
" The psychics on my bench is the same as Dumble'"
Thanks for sharing, Tony. Lots of very cool parts. Here's a 124ish with a board on the side that I can change the tone stack values by paralleling caps. The little tines are soldered together to make the connection. I put a slope control in the FET hole.
Drive control on OD1 and trimpot on OD 2. I know the ratio I want between OD1 & 2, but adjust the input to OD1 based upon the gain of CL2. More better.
You do not have the required permissions to view the files attached to this post.
Last edited by Smitty on Sun Feb 21, 2021 4:21 am, edited 2 times in total.