Hi Eric,dreric wrote:
The schematic says the secondary (red leads) off the PT are putting out 565.5 VAC. (this seems low, my PT puts out 669 VAC approx 100 volts more)
Bias stated at - 328 VDC (my value is -456 VDC approx 120 volts more)
Seems like the problem, for now, is that my PT puts out too much voltage (it's rated at 690 VAC). I could switch over to a Hammond, rated at 620 VAC. Does that seem like a good idea??
Eric
it seems the DC voltages in the hand drawn SSS #002 schematics were measured at a mains voltage of 102 VAC.
Regards,
Markus