After finishing the 1x15 speaker cab, I've been building a matching head for The Donut Princess.
The matching speaker cab is sapele carcase DTed with some wild maple panels I picked up here in Colorado for $6/bf. It's about 8 threads below this one. I used the original 12' x 15"(!) board's offcut and ripped it up the middle for a matching sapele head cab.
I cut the DT tail angles on the bandsaw, then hand chisel/saw/plane everything else. I had less gappy-but-still-gappier-than-I'd-like dovetails so I did the glue/sawdust trick to plug them up a bit.
Progress so far:
https://photos.app.goo.gl/rukQggeK5MzYSnLe7
The Donut Princess gets a Case
Moderators: pompeiisneaks, Colossal
-
- Posts: 84
- Joined: Thu Oct 02, 2014 3:34 pm
- Location: Longmont, CO
2 others liked this
The Donut Princess gets a Case
We build because we must.
Re: The Donut Princess gets a Case
Watch Paul Sellers do hand cut dovetails on youtube.
Nice lookin' cab. Can't see the flaws.
Nice lookin' cab. Can't see the flaws.