Steel String Singer#002 build from Scratch

[martin manning]

Keep the 2x 100R faux CT or the actual CT, just connect it to the elevated DC voltage instead of grounding it.

[timrobertson100]

Thanks Martin

[Hendrixianer]

Perhaps a daft question… you don’t use 100R balancing resistors when elevating the heaters?

There´s no Need for Balancing Heaters if using PT with Center Tap !!! it is already balanced!

[martin manning]

Some people believe that even if you have a center tap on the heater winding, a better balance can be achieved with two 100-ohm resistors, or even a pot to adjust the balance. You should use either the actual CT or the resistor CT, never both.

[Hendrixianer]

Some people believe that even if you have a center tap on the heater winding, a better balance can be achieved with two 100-ohm resistors, or even a pot to adjust the balance. You should use either the actual CT or the resistor CT, never both.

Than better use a wirewound Pot,called Humdinger to balance and eliminate Hum........

[Hendrixianer]

Added 12V PSU and Footswitchable Fet Boost,new 2-Way Foot Switch:

[novosibir]

Very nice build! Very clean! My congrats!

Just out of curiousity, what speaker(s) do you prefer with this amp?

Larry

[Hendrixianer]

Very nice build! Very clean! My congrats!

Just out of curiousity, what speaker(s) do you prefer with this amp?

Larry

Hi,Thanks,
I only use a 4x12 with Celestion G12H 75 Creambacks,and sounds Beutiful.

[Hendrixianer]

New Faceplate added: